HighPoint RocketRAID 2680 Manual de instalación - Página 6
Navegue en línea o descargue pdf Manual de instalación para Hardware informático HighPoint RocketRAID 2680. HighPoint RocketRAID 2680 8 páginas. Sas controller
Imprimir página
Rocket RAID 2680 FreeBSD Installation Guide
Note
On some systems with ACPI enabled, FreeBSD may not work. You can try to
disable ACPI in system BIOS or type the command "
hint.acpi.0.disabled="1"
6)
Before exit install, insert floppy driver diskette into (USB) floppy drive, or insert
USB driver disk into USB port, then an additional step must be taken to copy RR2680
driver module to system. On the driver disk, there is a setup script "postinstall" which
will do this work for you. Before you reboot the system, press Alt-F4 to the command
shell and type the following commands:
For common ISA floppy controller:
# mount –t msdosfs /dev/fd0 /mnt
For USB floppy controller, we assume it is da0:
# mount –t msdosfs /dev/da0 /mnt
For USB disk, we assume it is da1:
# mount –t msdosfs /dev/da1 /mnt
or
# mount –t msdosfs /dev/da1s1 /mnt
Then run script to do postinstall
# sh /mnt/postinstall
# umount /mnt
Then press Alt-F1 to return to the setup screen and choose [X Exit Install] to finish
setup.
Note
After the driver has been loaded, remove the floppy diskette from (USB) floppy
drive or remove USB disk from USB port to avoid that the installed system does
not boot normally.
set
" under boot prompt to solve the problem.
- 4 -