HighSecLabs CNMFE11PH-M Manual de configuración rápida - Página 8

Navegue en línea o descargue pdf Manual de configuración rápida para Hardware de red HighSecLabs CNMFE11PH-M. HighSecLabs CNMFE11PH-M 9 páginas. Secure extended isolators

Imprimir página

Table of Contents

SECTIONS

OPERATION

Running an EDID Capture

Before using the Isolator, run a one-time EDID capture on both sides – Transmitter and

Receiver. This prevents the continuous transfer of potentially malicious data - from the

display to the PC – that could infect the PC, cause data leakage, and so on.

Preparation:

•

Connect the PC and all peripherals to both the units, according to the

diagram.

•

Make sure the PC, display, and the units are ON.

To run an EDID capture:

On the Transmitter, short-click the CAPTURE button – for less than one

second.

Warning: Long-clicking the CAPTURE button sends the unit into an

undesired loop. If this happens, restart the unit and repeat the

procedure.

At first, the EDID LED flickers for a few seconds and then lights

continuously.

Make same on the Receiver, short-click the CAPTURE button – for less

than one second and wait until the EDID LED will light continuously.

Note: If the EDID LED is OFF, check the connections and that the PC or

the Display are powered ON. Then, repeat the procedure.

3. Restart the both units.

Secure Extended Isolators Quick Setup Guide

EDID

Lock/Capture

Note: An EDID capture needs to be

performed for new installations and

when changing a display.

Receiver