Gallo Tech GStarter I Manual de funcionamiento e instalación - Página 3
Navegue en línea o descargue pdf Manual de funcionamiento e instalación para Arranque a distancia Gallo Tech GStarter I. Gallo Tech GStarter I 12 páginas. Push button start & alarm system with 2 remote key fobs
Imprimir página
Data bus Systems 2003 and newer GM Trucks/SUV's, '96-04 Jeep Grand Cherokee
Data bus systems send low current "Data messages" to the door lock controllers on a network in order to
lock and unlock the vehicle. To install aftermarket systems in these vehicles, an interface module is required
that converts the regular lock/unlock pulses into "Data messages" to allow locking & unlocking. This type
system requires that you have a good working knowledge of their operation before attempting installation of
alarm functions. "Engine Start" only function can be easily installed.
1.2 REMOTE KEY FOB OPERATION:
(Lock Button): Arm/Remote- Lock/Panic/Siren-Stop
a.) Arms the system and locks the doors with one press
Siren will chirp once and parking lights flash once. The blue LED on the Engine Start button will flash
slowly.
The alarm will chirp and parking lights will flash 3 times if all the doors are not closed during arming.
You must wait 3 seconds after closing all the doors before the arm button can be pressed to arm the
system.
If the alarm siren has been triggered, pressing this button one time will silence the siren and keep
the system in the armed mode.
b.) Panic:
When ignition switch is OFF, holding this button for over 2 seconds will cause the siren to sound for
30 seconds and the system will remain in the armed mode.
c.) Lock only (when vehicle occupied)
When the ignition key is in the ON position, and the system is disarmed, pressing this button will
lock the doors. The system will stay in the disarmed mode.
.
(Unlock Button): Disarm/Remote-Unlock/Release-Anti-hijack.
a.) Disarm the system and unlock the doors with one press
Siren will chirp twice and the parking lights will flash twice. The green LED on the Engine Start
button will flash rapidly. The doors will unlock and the system will be in the disarmed mode.
Within 30 seconds after pressing the button, if a door is not opened or the ignition key is not turned
to the ON position, the system will automatically rearm and relock the doors.
If the system has been triggered while in the armed mode, the siren will chirp and the parking lights
will flash four times, when the unlock button is pressed.
b.) Unlock only (when vehicle occupied)
When the ignition key is in the ON position, and the system is disarmed, pressing this button will
unlock the doors. The system will stay in the disarmed mode.
c.) Release Anti-Hijack:
When the alarm system is in the anti-hijack mode, pressing this button will release the anti-hijacking
mode.
Mute Button: Mute-(Arm/Disarm)/Remote-Lock/Siren-Stop
a.) Mute Arm:
When in disarmed mode press
button will flash slowly, the siren will not chirp, the doors will lock and system will be in armed mode. If a
door is not closed when pushing the
times and the system will stay in the armed mode. When the door is closed the system will be in the
armed mode.
Siren stop: When the alarm siren is triggered, pressing the
siren sounding and the system will stay in the armed mode. Pressing the
system and unlock the doors.
b.) Mute Disarm:
When in the armed mode, press
© Copyright
Gallo
Technologies. All Right Reserved
one time, parking lights flash once, Blue L.E.D. on the Engine Start
button, the siren will chirp and the parking lights will flash 3
one time then press
- 3 -
button or the
button will stop the
button will disarm the
will mute the disarm siren.
52008