Gallo Tech GStarter I Instrukcja obsługi i instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Zdalny rozrusznik Gallo Tech GStarter I. Gallo Tech GStarter I 12 stron. Push button start & alarm system with 2 remote key fobs

Drukuj stronę



Data bus Systems 2003 and newer GM Trucks/SUV's, '96-04 Jeep Grand Cherokee

Data bus systems send low current "Data messages" to the door lock controllers on a network in order to

lock and unlock the vehicle. To install aftermarket systems in these vehicles, an interface module is required

that converts the regular lock/unlock pulses into "Data messages" to allow locking & unlocking. This type

system requires that you have a good working knowledge of their operation before attempting installation of

alarm functions. "Engine Start" only function can be easily installed.

1.2 REMOTE KEY FOB OPERATION:

(Lock Button): Arm/Remote- Lock/Panic/Siren-Stop

a.) Arms the system and locks the doors with one press



Siren will chirp once and parking lights flash once. The blue LED on the Engine Start button will flash

slowly.



The alarm will chirp and parking lights will flash 3 times if all the doors are not closed during arming.

You must wait 3 seconds after closing all the doors before the arm button can be pressed to arm the

system.



If the alarm siren has been triggered, pressing this button one time will silence the siren and keep

the system in the armed mode.

b.) Panic:



When ignition switch is OFF, holding this button for over 2 seconds will cause the siren to sound for

30 seconds and the system will remain in the armed mode.

c.) Lock only (when vehicle occupied)



When the ignition key is in the ON position, and the system is disarmed, pressing this button will

lock the doors. The system will stay in the disarmed mode.

(Unlock Button): Disarm/Remote-Unlock/Release-Anti-hijack.

a.) Disarm the system and unlock the doors with one press



Siren will chirp twice and the parking lights will flash twice. The green LED on the Engine Start

button will flash rapidly. The doors will unlock and the system will be in the disarmed mode.



Within 30 seconds after pressing the button, if a door is not opened or the ignition key is not turned

to the ON position, the system will automatically rearm and relock the doors.



If the system has been triggered while in the armed mode, the siren will chirp and the parking lights

will flash four times, when the unlock button is pressed.

b.) Unlock only (when vehicle occupied)



When the ignition key is in the ON position, and the system is disarmed, pressing this button will

unlock the doors. The system will stay in the disarmed mode.

c.) Release Anti-Hijack:



When the alarm system is in the anti-hijack mode, pressing this button will release the anti-hijacking

mode.

Mute Button: Mute-(Arm/Disarm)/Remote-Lock/Siren-Stop

a.) Mute Arm:



When in disarmed mode press

button will flash slowly, the siren will not chirp, the doors will lock and system will be in armed mode. If a

door is not closed when pushing the

times and the system will stay in the armed mode. When the door is closed the system will be in the

armed mode.



Siren stop: When the alarm siren is triggered, pressing the

siren sounding and the system will stay in the armed mode. Pressing the

system and unlock the doors.

b.) Mute Disarm:



When in the armed mode, press

Gallo

one time, parking lights flash once, Blue L.E.D. on the Engine Start

button, the siren will chirp and the parking lights will flash 3

one time then press

- 3 -

button or the

button will stop the

button will disarm the

will mute the disarm siren.

52008