Galvin Engineering 201.10.70.10 Manuales de instalación - Página 6

Navegue en línea o descargue pdf Manuales de instalación para Unidad de control Galvin Engineering 201.10.70.10. Galvin Engineering 201.10.70.10 13 páginas. Lead safe thermostatic mixing valve cabinet

Imprimir página
Product Installation Guidelines & Scope of Use

7.0 INSTALLATION

INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these
installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.
Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
Failing to comply with these provisions shall void the product warranty and may affect the performance of the
product.
1. Remove cabinet door
1.
Open the cabinet door
2.
Pull hinge down to allow removal of the
door. Remove the door from cabinet.
© Galvin Engineering Pty Ltd
Back Mount
2. Secure the cabinet
Insert cabinet into wall opening.
Mount cabinet in wall using four fasteners, only securing
hand tight.
If side mounting, make sure door frame has clearance and
can slide after fastening the cabinet.
Note: The cabinet must be mounted with four
fasteners for stability and strength. This is critical,
failure to do this may void the warranty.
Version 1, 13 November 2023, Page 6 of 13
Side Mount