Galvin Engineering 201.10.70.10 설치 매뉴얼 - 페이지 6

{카테고리_이름} Galvin Engineering 201.10.70.10에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering 201.10.70.10 13 페이지. Lead safe thermostatic mixing valve cabinet

페이지 인쇄

Product Installation Guidelines & Scope of Use

7.0 INSTALLATION

INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these

installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.

Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.

Failing to comply with these provisions shall void the product warranty and may affect the performance of the

product.

1. Remove cabinet door

Open the cabinet door

Pull hinge down to allow removal of the

door. Remove the door from cabinet.

Back Mount

2. Secure the cabinet



Insert cabinet into wall opening.



Mount cabinet in wall using four fasteners, only securing

hand tight.



If side mounting, make sure door frame has clearance and

can slide after fastening the cabinet.

Note: The cabinet must be mounted with four

fasteners for stability and strength. This is critical,

failure to do this may void the warranty.

Version 1, 13 November 2023, Page 6 of 13

Side Mount