AGS Merlin 2000S Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Detectores de gas AGS Merlin 2000S. AGS Merlin 2000S 12 páginas. Gas proving and ventilation interlock system
También para AGS Merlin 2000S: Manual de instalación y funcionamiento (12 páginas), Manual de instalación y funcionamiento (12 páginas)

Merlin 2000S

Circuit Board Terminals

2.1

A 110-120VAC electrical supply should be externally fused at

3A and connected to the terminals marked [LINE VOLTAGE

LNE].

2.2

The 110-120VAC gas solenoid valve should be powered using

the terminals on the Merlin 1000S detailed [VALVE OUT LNE].

2.3

SUPPLY FAN & EXTRACT FAN PD SWITCHES

These terminals are used to receive an input signal from external air pressure switches or external

current monitors. These are linked out as a factory setting as shown.

2.4

Terminal connections are available on the circuit board for connections to

Building Management systems.

This is a relay that changes state in alarm or when gas is on/off and can be

used in conjunction with the [12VDC] output and other external relays that

affect other devices and controls such as purge fans, audible alarms etc.

Detailed on the circuit board as [BMS OUT] normally closed (N/C),

common (COM) and normally open (N/O). These are volt free

connections.

2.5

The terminals marked pressure sensor [+ - IN].

These wire to the gas pressure sensor which is

screwed into the downstream port on the gas

solenoid valve.

Min Operating Pressure = 0.17psi

Max Operating Pressure = 1.45psi

ENSURE THIS IS SCREWED TO THE DOWNSTREAM PORT OF THE GAS SOLENOID VALVE

Rev: 06

05-19

Wiring to switches & current monitors should be made using

two-core volt free connections.

If only one fan is being used the terminals not in use should be

left linked out.

User Guide