Galvo Shed GVO 2315 Manual de instrucciones de montaje - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Almacenamiento exterior Galvo Shed GVO 2315. Galvo Shed GVO 2315 8 páginas. Sloping roof shed
Imprimir página
STEP 6
END WALLS
Cap the sloping sheets
E
Fix the channels through the end ribs and every second rib in between.
Make sure you put at least two fixings up through the underside of the
channel into the pan of the sheet.
Repeat for other side wall with opposite slope.
STEP 7
DOOR BRACES
The door braces can be fitted now or after you have assembled your shed.
Tuck one end of the 'Z' between the bottom channel of the inside of the
door and the sheet. Do the same at the top, overlapping in the centre
behind the padbolt. If you have a locking 'T' handle you will have to run
the 'Z's the opposite way to the diagram.
Rivet the 'Z's at the ends, and in the centre of the channel it is tucked
under, and through the overlap in the centre. Two or three more fixings will
be required through the door sheeting into the 'Z', but they will need to be
riveted through from the outside of the door for a neater appearance.
You may need to cut or bend the flange at the bottom and the top of the
'Z' if it catches on the door jamb when opening or closing (diagram 1).
DIAGRAM 1
BEFORE
6
with the 'U' channels
.
G
G
5
E
AFTER
If you choose to vary from these instructions your warranty will be impaired
YOU WILL NEED
4 x 1980mm - 1830mm sloping sheets
E
(side walls 2 left, 2 right)
G
4 x 1485mm channels (2 per side)
G
YOU WILL NEED
O
2 x 'Z' Door braces
N
Fixings