Galvo Shed GVO 2315 Montagehandleiding - Pagina 6

Blader online of download pdf Montagehandleiding voor {categorie_naam} Galvo Shed GVO 2315. Galvo Shed GVO 2315 8 pagina's. Sloping roof shed

STEP 6

END WALLS

Cap the sloping sheets

Fix the channels through the end ribs and every second rib in between.

Make sure you put at least two fixings up through the underside of the

channel into the pan of the sheet.

Repeat for other side wall with opposite slope.

STEP 7

DOOR BRACES

The door braces can be fitted now or after you have assembled your shed.

Tuck one end of the 'Z' between the bottom channel of the inside of the

door and the sheet. Do the same at the top, overlapping in the centre

behind the padbolt. If you have a locking 'T' handle you will have to run

the 'Z's the opposite way to the diagram.

Rivet the 'Z's at the ends, and in the centre of the channel it is tucked

under, and through the overlap in the centre. Two or three more fixings will

be required through the door sheeting into the 'Z', but they will need to be

riveted through from the outside of the door for a neater appearance.

You may need to cut or bend the flange at the bottom and the top of the

'Z' if it catches on the door jamb when opening or closing (diagram 1).

DIAGRAM 1

BEFORE

with the 'U' channels

AFTER

If you choose to vary from these instructions your warranty will be impaired

YOU WILL NEED

4 x 1980mm - 1830mm sloping sheets

(side walls 2 left, 2 right)

4 x 1485mm channels (2 per side)

YOU WILL NEED

2 x 'Z' Door braces

Fixings