AFL IDEAA 144F Manual de instrucciones de instalación - Página 13

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Recinto AFL IDEAA 144F. AFL IDEAA 144F 14 páginas.

Recommendation: For best practice no more than 35" (88.9 cm) of 900 µm fiber be exposed for the MDU

drop cable installation process. This length will optimize the routing capability within the IDC and prevent

excessive lengths of 900 µm fiber from collecting within the cabinet.

5. Insert the 4.8mm jacket into the drop retention bracket. (Figure 24)

Figure 22

6. Slide the 4.8 mm drop cable to the backmost position within the drop retention bracket.

7. Ensure that the exposed 900 µm fiber is long enough

to reach the desired IDEAA Splitter Module port.

8. Repeat steps 4 – 7 for all desired MDU drop cables.

9. Once all MDU drop cables have been installed, replace

the drop access plate.

10. Using a standard 216 style tool, or similar, replace the

two nuts that secure the MDU drop access plate to the

cabinet body and cover with caps. (Figure 25)

11. Install FASTConnect

Reference the installation instructions provided with the

FASTConnect

Mechanical Connector. The document

will include the following:

• Fiber Preparation

• Fiber Termination

• Connector Assembly

12. Using local engineering practices, determine which

port on the IDEAA Splitter Module will be used for

the MDU drop connection.

13. Use local accepted practices to clean the distribution

fiber connector end face.

14. Connect the distribution fiber to the appropriate port on

the IDEAA Splitter Module. Use the foam fiber relief to

route the distribution fiber to the fiber routing section

of the IDC, employing a similar technique to that used

with the input jumper cable. (Figure 26)

Mechanical Connector.

INSTALLATION INSTRUCTIONS

Figure 23

IDEAA

Interior Distribution Cabinet

Figure 24

Replace

Nuts & Caps

Figure 25

Figure 26

Specifications are subject to change without notice.