GAME SolarPRO XD3 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Calentador de piscina GAME SolarPRO XD3. GAME SolarPRO XD3 12 páginas.

6.

MAINTENANCE

To prevent damage, the solar coils should always be covered with the clear acrylic dome included in the package. The solar heater
should not require servicing or maintenance other than winterizing. Prior to the first frost, or at the end of your swim season, the solar
heater should be removed from its connections to the pool and stored in a frost free location.
Winterizing
Drain all the water from the solar heater by disconnecting the tubes. Store in a location protected from frost. Reconnect the pool return
tubes with a 1½"-1½" coupler (not included) or any properly sized 2-way valve if continued pool use is desired.
CAUTION: DO NOT ALLOW STANDING WATER INSIDE THE SOLAR HEATER TO FREEZE. WATER EXPANDS AS IT FREEZES AND
CAN RUPTURE THE SOLAR COILS ON THE HEATER.
7.

TROUBLESHOOTING

Problem
Does not appear to be heating the
pool.
No initial bubbling after heater is
connected and pump is on.
Bubbles continue
to flow out of the pool water inlet well
after the pump has been turned on.
Leaking heater
High filter pressure
SAVE THESE INSTRUCTIONS
Possibilities/Solutions
• Check to make sure that water is flowing through the holes. Check the flow strength at the
pool inlet.
• Has it been sunny?
• Put your pool cover on at night to prevent heat loss.
• Additional heaters may be necessary.
• If using a bypass kit, check and adjust flow restrictions if necessary.
• Check the setting of the filter to make sure it is returning water to the pool through the
pool water inlet.
• Check flow rate.
• Check the connections for a suction leak.
• Check to make sure the flow rate is normal.
• There could be a break in the tubing.
• There could be a clog in the tubing, try to purge out
the clog.
• Check the connector seals and replace or repair
if defective.
• Flow through heather may be too high. A bypass kit may be needed.
• Filter may need backwashing or filter media change.
• Pool/spa system valves may need adjusting.
• Water return outlet may be blocked.
8