GAME SolarPRO XD3 Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Aquecedor de piscinas GAME SolarPRO XD3. GAME SolarPRO XD3 12 páginas.

MAINTENANCE

To prevent damage, the solar coils should always be covered with the clear acrylic dome included in the package. The solar heater

should not require servicing or maintenance other than winterizing. Prior to the first frost, or at the end of your swim season, the solar

heater should be removed from its connections to the pool and stored in a frost free location.

Winterizing

Drain all the water from the solar heater by disconnecting the tubes. Store in a location protected from frost. Reconnect the pool return

tubes with a 1½"-1½" coupler (not included) or any properly sized 2-way valve if continued pool use is desired.

CAUTION: DO NOT ALLOW STANDING WATER INSIDE THE SOLAR HEATER TO FREEZE. WATER EXPANDS AS IT FREEZES AND

CAN RUPTURE THE SOLAR COILS ON THE HEATER.

Problem

Does not appear to be heating the

pool.

No initial bubbling after heater is

connected and pump is on.

Bubbles continue

to flow out of the pool water inlet well

after the pump has been turned on.

Leaking heater

High filter pressure

SAVE THESE INSTRUCTIONS

Possibilities/Solutions

• Check to make sure that water is flowing through the holes. Check the flow strength at the

pool inlet.

• Has it been sunny?

• Put your pool cover on at night to prevent heat loss.

• Additional heaters may be necessary.

• If using a bypass kit, check and adjust flow restrictions if necessary.

• Check the setting of the filter to make sure it is returning water to the pool through the

pool water inlet.

• Check flow rate.

• Check the connections for a suction leak.

• Check to make sure the flow rate is normal.

• There could be a break in the tubing.

• There could be a clog in the tubing, try to purge out

the clog.

• Check the connector seals and replace or repair

if defective.

• Flow through heather may be too high. A bypass kit may be needed.

• Filter may need backwashing or filter media change.

• Pool/spa system valves may need adjusting.

• Water return outlet may be blocked.