Dean Sherford Slimline 5 Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Estufa Dean Sherford Slimline 5. Dean Sherford Slimline 5 17 páginas.

The chimney must be sound and not too large in section. If not sound or too large, a liner will

have to be fitted; Stainless steel or ceramic liner suitable for solid fuel.

If the chimney draw is too high a flue stabilizer will have to be installed. When the chimney is

warm the draw should not be lower than 0.10 water gauge.

All appliances have been tested at 12 PA with the doors closed.

When a flue is connected directly into an existing chimney without a liner the register plate

must be fitted with removable doors to facilitate cleaning. If it not possible to fit doors in the

length of flue in the front, side or back of the chimney breast.

Hearth, Surround and Register Plate

The stove must stand on non-flammable material at least 12mm thick (1/2"). The hearth must

extend 300mm in front of the firebox and 150mm to the sides.

If the stove is installed into a fire opening made of non-combustible materials, we recommend

a minimum of 150mm gap to the sides and 300mm above from non-combustible materials.

The appliance must be installed on a floor with an adequate low bearing capacity.

If the construction doesn't meet the existing prerequisite the floor must be reinforced or a load

distributing plate could be fitted.

Due to the weight of the Sherford Slimline 5 door you must secure the stove to the hearth to

prevent the possibility of the stove toppling forward when opening the door. This can be done

by using the two rear brackets supplied. Two sleeve anchors are also supplied if the sleeve

anchors are not suitable for your particular installation then you must source suitable fixings.

See diagram below.