Dean Sherford Slimline 5 Інструкція з експлуатації Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Піч Dean Sherford Slimline 5. Dean Sherford Slimline 5 17 сторінок.
Друкувати сторінкуThe chimney must be sound and not too large in section. If not sound or too large, a liner will
have to be fitted; Stainless steel or ceramic liner suitable for solid fuel.
If the chimney draw is too high a flue stabilizer will have to be installed. When the chimney is
warm the draw should not be lower than 0.10 water gauge.
All appliances have been tested at 12 PA with the doors closed.
When a flue is connected directly into an existing chimney without a liner the register plate
must be fitted with removable doors to facilitate cleaning. If it not possible to fit doors in the
register plate then a cleaning door will need to be fitted as near as possible to the connecting
length of flue in the front, side or back of the chimney breast.
Hearth, Surround and Register Plate
The stove must stand on non-flammable material at least 12mm thick (1/2"). The hearth must
extend 300mm in front of the firebox and 150mm to the sides.
If the stove is installed into a fire opening made of non-combustible materials, we recommend
a minimum of 150mm gap to the sides and 300mm above from non-combustible materials.
The appliance must be installed on a floor with an adequate low bearing capacity.
If the construction doesn't meet the existing prerequisite the floor must be reinforced or a load
distributing plate could be fitted.
Due to the weight of the Sherford Slimline 5 door you must secure the stove to the hearth to
prevent the possibility of the stove toppling forward when opening the door. This can be done
by using the two rear brackets supplied. Two sleeve anchors are also supplied if the sleeve
anchors are not suitable for your particular installation then you must source suitable fixings.
See diagram below.
7