GameChanger Audio BIGSBY Manual de inicio rápido - Página 6

Navegue en línea o descargue pdf Manual de inicio rápido para Pedal de música GameChanger Audio BIGSBY. GameChanger Audio BIGSBY 8 páginas.

Imprimir página

SETTINGS MENU

To enter the SETTINGS menu press and hold the SELECT button for 8+ seconds.
You've successfully entered the settings menu when you've seen a LED sequence on the
pedal's knobs and the SELECT button is blinking.
Exit the SETTINGS menu by holding the SELECT button for 8 seconds.
The settings menu is also structured as 2 layers - WHITE and RED. You can toggle between the
WHITE and RED layers with the SELECT button.
The WHITE layer allows you to adjust the following EXPRESSION OUT parameters:
EXP RANGE - adjusts the maximum range of expression out signal when pedal is used.
EXP OFFSET - the level of expression out signal when pedal is not pressed down (bypass).
EXP INVERT - this is a binary parameter for the direction of the expression out signal.
When the knob is dark the EXP out signal's direction corresponds to the pedal's movement.
When the knob is white - the EXP out signal's direction is inverted to the pedal's movement.
The RED layer lets you set up the following MIDI Parameters:
MIDI CHANNEL SELECT
By default the BIGSBY Pedal is set up on MIDI channel 1, but you can change that to any MIDI
channel between 1 and 16 by using the MIDI setup knobs:
MIDI setup LOW and HI are both divided into four steps and each step will be indicated by an
according blinking sequence - one blink for step 1, two for step 2 etc.
The MIDI Setup HI knob lets you select between four value ranges:
1-4
5-8
9-12
The MIDI setup LOW knob lets you dial in a value between one and four - which represents the
corresponding position in that value range.
Example:
If you wish to set your BIGSBY Pedal to MIDI channel 2 then set the MIDI setup HI knob to it's
minimum value (range 1-4) and then set the MIDI setup LOW to the second step (two blinks).
To set up channel 12 set the MIDI setup HI value to 3 (three blinks) which represents the value
range 9-12.
Next use the MIDI setup LOW knob and turn it all the way up (four blinks) - this will indicate
the fourth position in the value range 9-12 - i.e. channel 12.
Alternatively, hold down the SELECT button and power the Pedal on by inserting the
power supply jack.
The BIGSBY Pedal is now looking for the first incoming PC or CC
message and will set itself to whatever channel the first
message is sent from.
MIDI SYNC
MIDI SYNC Knob - enables/disables synchronization of the
BIGSBY pedal's Auto Mode with an external MIDI Clock.
When the knob is dark, the pedal is NOT synced to a MIDI Clock
source and the RATE knob will adjust the vibrato speed
continuously.
When the knob is RED, the BIGSBY Pedal is synced to a MIDI
Clock source and the RATE knob can be used to dial in various
beat subdivisions for the Auto Vibrato function:
13-16
1)
2
2)
1.5
3)
1
4)
3/4
5)
1/2
6)
3/8
7)
1/3
8)
1/4
9)
3/16
10)
1/6
11)
1/8
12)
1/12
13)
1/16
14)
1/24
15)
1/32
6