Bristan ALP 2HBF C Instrucciones de instalación y manual del usuario - Página 14
Navegue en línea o descargue pdf Instrucciones de instalación y manual del usuario para Productos de fontanería Bristan ALP 2HBF C. Bristan ALP 2HBF C 20 páginas.
Imprimir página
Installation Cont.
2 Hole Bath Filler
1. Fit the spout and the side body to the
bath ensuring that the washers are fitted
between the bodies and the fixing surface
to create a water tight seal.
2. Secure the spout to the bath using the
washer and metal backnut. Tighten the
backnut onto the threaded tail. A suitable
spanner may be required to fully tighten
the backnut.
3. Screw the fixing rod into the bottom of
the side body. Slide the 'C' shaped rubber
washer and 'C' shaped metal washer
onto the fixing rod up to the underside of
the bath.
4. To secure the side body in place
tighten the fixing nut onto the fixing rod
until it is fully tightened against the 'C'
shaped metal washer. The fixing nut can
be tighten with a suitable spanner.
5. Screw the flexi tails into the bottom of
the side body by hand only
(DO NOT OVERTIGHTEN).
6. Connect the flexi tails to the side body
(hot on the left, cold on the right when
viewed from the front) and connect to the
water supplies.
7. Connect the spout to the side body by
using flexi tails supplied.
8. Turn on both water supplies, operate
the handle in both directions, letting the
water flow for a few minutes to flush
through the system.
9. Check all joints and connections for
leaks.
14