Bristan Regency Luxury R TBSM C Instrucciones de instalación y manual del usuario - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación y manual del usuario para Productos de fontanería Bristan Regency Luxury R TBSM C. Bristan Regency Luxury R TBSM C 7 páginas. Bath shower mixer
Imprimir página
3. Specification
Operating Pressure Range (bar)
Bath Shower Mixer
Maximum Static Pressure – 10 bar
NOTE: Nominally equal (balanced) inlet supply pressures are recommended for optimum
performance
Designed to comply with BS EN 200 for single taps/combination taps for water systems
of type 1 and 2 general technical specifications and to be used within systems designed
to BS 6700.
BS6700 recommends the temperature of stored water should never exceed 65°C. A
stored temperature of 60°C is considered sufficient to meet all normal requirements and
will minimise the build up of lime scale in hard water areas
4. Installation
This mixer is suitable for use at all supply pressures. However, for optimum
performance, use both hot and cold water supplies, which should be ideally balanced.
Operating Pressures: Min. 0.2 Bar – Max. 5.0 Bar
If the fitting is installed at low pressure (tank fed), then the minimum distance from the
underside of the nozzle to the cold water tank should be at least 2 metres to ensure
adequate shower performance.
This mixer should be installed in compliance with Water Regulations.
Where the supplies are balanced, i.e. hot water from the cylinder tank and cold from the
mains, approved check valves must be fitted in the supply pipes.
For further details, please contact your Local Water Authority.
Min.
Max.
0.2
5.0