- ページ 3

配管製品 Bristan Regency Luxury R TBSM CのPDF 取付説明書＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bristan Regency Luxury R TBSM C 7 ページ。 Bath shower mixer

3. Specification

Operating Pressure Range (bar)

Bath Shower Mixer

Maximum Static Pressure – 10 bar

NOTE: Nominally equal (balanced) inlet supply pressures are recommended for optimum

performance

Designed to comply with BS EN 200 for single taps/combination taps for water systems

of type 1 and 2 general technical specifications and to be used within systems designed

to BS 6700.

BS6700 recommends the temperature of stored water should never exceed 65°C. A

stored temperature of 60°C is considered sufficient to meet all normal requirements and

will minimise the build up of lime scale in hard water areas

This mixer is suitable for use at all supply pressures. However, for optimum

performance, use both hot and cold water supplies, which should be ideally balanced.

Operating Pressures: Min. 0.2 Bar – Max. 5.0 Bar

If the fitting is installed at low pressure (tank fed), then the minimum distance from the

underside of the nozzle to the cold water tank should be at least 2 metres to ensure

adequate shower performance.

This mixer should be installed in compliance with Water Regulations.

Where the supplies are balanced, i.e. hot water from the cylinder tank and cold from the

mains, approved check valves must be fitted in the supply pipes.

For further details, please contact your Local Water Authority.

Min.

Max.

0.2

5.0