Majestic fireplaces 20010751 Instrucciones de instalación - Página 3

Navegue en línea o descargue pdf Instrucciones de instalación para Accesorios para chimeneas Majestic fireplaces 20010751. Majestic fireplaces 20010751 4 páginas. Fuel conversion kit lp to natural/natural to lp for model dv360

Imprimir página

4. Converting LP to NG, remove bracket/gasket as-

sembly by unfastening the screw which secures the

bracket to the burner tray base. Discard bracket and

refasten the screw into the hole. (Fig. 9)

Converting NG to LP, assemble the bracket/gas-

ket assembly to the burner tray assembly base by

unfastening the screw on the tray to the right side of

the oriﬁce. Slide the bracket/gasket assembly over

the ﬁtting on the manifold toward the back with the

gasket to the right. Secure the bracket/gasket as-

sembly using the screw removed earlier. (Fig. 9)

Fig. 9 LP bracket/gasket assembly.

5. Replace the oriﬁces according to the table on Page

��

6. Replace the mixing tube on the burner housing by

removing the two (2) screws that secure the mixing

��

tube to the burner housing assembly. Remove the

old gasket behind the mixing tube. (Fig. 10) NOTE:

The mixing tube for propane gas has only two

bimetallic springs that are in the closed position

at cold start. The mixing tube for natural gas has

two spring/shutter collar assemblies that are in

the closed position at cold start. Make sure the

correct mixing tube is used for conversion.

7. Use the new gasket supplied in the conversion kit

and proper mixing tube and replace in reverse order.

8. Reassemble the burner housing assembly, the

burner tube assembly and the fettle in reverse orde

Pilot Oriﬁce Conversion - R Models

NOTE: It is not necessary to remove the pilot tube for

conversion.

1. Remove pilot hood by lifting up. (Fig. 11)

2. Remove pilot oriﬁce with Allen wrench. (Fig. 12)

3. Install conversion pilot oriﬁce.

4. Re-install pilot hood and be sure to align with index

tab. Installation is complete.

LP Bracket/Gas-

ket Assembly - in

Fig. 10 Replace mixing tube and gasket.

place for use with

LP Gas; remove

for use with Natu-

ral Gas

Screw

CO132

Fig. 11 Remove pilot hood.

Fig. 12 Remove pilot oriﬁce.

Pilot Oriﬁce Conversion - RF Models

NOTE: It is not necessary to remove the pilot tube for

1. Loosen pilot hood turning counterclockwise using a

2. Remove pilot oriﬁce with needlenose pliers. (Fig. 14)

3. Install conversion pilot oriﬁce.

4. Reinstall pilot hood. Be sure to align pilot hood with

5. Turn the gas supply valve and gas valve on and test

6. Follow procedure on rating plate to light the pilot.

Gasket

Mixing Tube

Natural

Pilot Hood

Pilot

Bracket

Index Tab

Snap Ring

conversion.

CO106a

DV360/580

Gas Conversion

7/16" wrench. (Fig. 13)

Pilot2

1/28/00 djt

index marks.

for leaks. Use a 50/50 solution of liquid soap and

water to test for leaks at gas ﬁttings and joints. Apply

water/soap solution with brush only - do not over ap-

ply. NEVER test with an open ﬂame.

Check for leaks.

Burner Housing

Propane

CO131

��

CO105a

Allen Wrench