Gamma 5003 Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Máquinas de encordar Gamma 5003. Gamma 5003 19 páginas. 6 point mounting
También para Gamma 5003: Manual del usuario (20 páginas), Manual del usuario (20 páginas), Manual del usuario (20 páginas)

Imprimir página

1. Tension Calibration

STRING CLAMP ADJUSTMENT

Adjustment

Knob

Note: The string clamps supplied with your Gamma stringing machine can accomodate tight string patterns such as

badminton. Depending on the string pattern, the clamp may spread the strings slightly which will not compromise the

quality of the string job.

STRINGING THE FRAME

Weaving the Cross Strings

Weave the cross strings over and under the main strings

being careful to alternate the weave direction of each

consecutive cross string so as to be opposite of the

previously installed cross string.

Once the final cross string is tensioned and clamped, tie

off at the appropriate hole specified by the racquet

manufacturer.

Adjusting the Clamp Jaws

The GAMMA "Quick Action" Clamps will need minor

adjustments according to what string type, construction,

and gauge you are using.

To adjust the gap (clamping pressure) between the

clamp jaws, insert the string through the racquet as if you

were beginning the main strings. Clamp the strings and

pull tension. If the string slips through the jaws of the

clamp, tighten the clamp by compressing the clamp

jaws together by hand while turning the Adjustment

Knob, in the clockwise direction. If the clamp leaves

impressions or damages the string, it may be exces-

sively tight and should be adjusted by turning the hex

screw counter clockwise to open the gap between the

jaws. The clamp jaws should be cleaned periodically to

be free from dirt, oil, and any string coating for them to

grip properly.

Adjusting the Clamp Base Locking Nut

In the event the Locking Lever rotation is innsufficient to

ensure smooth operation of the clamp base, very minor

adjustments to the Clamp Base Locking Nut can be

made with the supplied 17mm wrench. Tighten or loosen

the locking nut in very small increments to provide more

clamping pressure or running clearance as needed.