Gamma 6004 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Máquinas de encordar Gamma 6004. Gamma 6004 20 páginas. 6 point mounting
También para Gamma 6004: Manual del usuario (20 páginas), Manual del usuario (20 páginas), Manual del usuario (19 páginas)

Gamma 6004 Manual del usuario
ASSEMBLY INSTRUCTIONS
until the posts of the frame support slides fi t inside the head of the racquet. Lower the racquet
over the posts and adjust the mounting stands until the posts just make contact with the inside
surface of the racquet head at its center points located at 6 and 12 o'clock.
the mounting stand adjustment knob at either end of the turntable until they are snug.

MOUNTING THE FRAME

Height Adjustment
The turntable height can be adjusted to suit
the stringer. To adjust, loosen the two set
screws on the lower column support post
below the bellows assembly. Adjust the
amount of engagement between the upper
and lower column supports until the desired
height is attained. Make sure that the tension
track is still aligned with the long leg of the
base and tighten the two set screws to lock
the upper support column into place.
Mounting Stand Adjustment
To adjust the spacing between the mount-
ing stands, turn one of the knobs located
at either end of the turntable. There is an
arrow on the face of each knob indicating the
turning direction that will "Tighten" the mount-
ing points and move the mounting stands
further apart to bring the posts of the frame
support slides closer to the inside surface of
the racquet head. Turning the knobs in the
opposite direction will move the mounting
stands closer together. When mounting a
racquet, adjust the mounting stand spacing
Adjusting the Frame Support Slide
Center the racquet over the mounting
stands. Press the quick release button
on the mounting stand, located below the
shoulder support knob, and lock the frame
support slide into one of the three positions
depending on the shape and head size of
the racquet. For larger head sizes position
the frame support closer to the mounting
stand and further away for smaller head
sizes. Check to make sure the quick re-
lease lock is fully seated in the groove on
the frame support hex shaft. Tighten the
frame supports on the racquet by turning
8