Gamma 6004 Kullanıcı El Kitabı - Sayfa 8

Tel Çekme Makineleri Gamma 6004 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gamma 6004 20 sayfaları. 6 point mounting
Ayrıca Gamma 6004 için: Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (19 sayfalar)

Sayfayı Yazdır

ASSEMBLY INSTRUCTIONS

until the posts of the frame support slides ﬁ t inside the head of the racquet. Lower the racquet

over the posts and adjust the mounting stands until the posts just make contact with the inside

surface of the racquet head at its center points located at 6 and 12 o'clock.

the mounting stand adjustment knob at either end of the turntable until they are snug.

MOUNTING THE FRAME

Height Adjustment

The turntable height can be adjusted to suit

the stringer. To adjust, loosen the two set

screws on the lower column support post

below the bellows assembly. Adjust the

amount of engagement between the upper

and lower column supports until the desired

height is attained. Make sure that the tension

track is still aligned with the long leg of the

base and tighten the two set screws to lock

the upper support column into place.

Mounting Stand Adjustment

To adjust the spacing between the mount-

ing stands, turn one of the knobs located

at either end of the turntable. There is an

arrow on the face of each knob indicating the

turning direction that will "Tighten" the mount-

ing points and move the mounting stands

further apart to bring the posts of the frame

support slides closer to the inside surface of

the racquet head. Turning the knobs in the

opposite direction will move the mounting

stands closer together. When mounting a

racquet, adjust the mounting stand spacing

Adjusting the Frame Support Slide

Center the racquet over the mounting

stands. Press the quick release button

on the mounting stand, located below the

shoulder support knob, and lock the frame

support slide into one of the three positions

depending on the shape and head size of

the racquet. For larger head sizes position

the frame support closer to the mounting

stand and further away for smaller head

sizes. Check to make sure the quick re-

lease lock is fully seated in the groove on

the frame support hex shaft. Tighten the

frame supports on the racquet by turning