Gamma X-Stringer XLT Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Accesorios Gamma X-Stringer XLT. Gamma X-Stringer XLT 20 páginas. Electronic stringing machine

Gamma X-Stringer XLT Manual del usuario

ASSEMBLY INSTRUCTIONS

Leg Bracket with Foot Pads
There are four rubber foot pads supplied
with the machine. Two have exposed
threads and two have a spacer sleeve
over the threads. Install the two rubber
foot pads with the exposed threads into
the outer holes on both ends of the leg
bracket.
Mounting the Leg Bracket
Insert two hex head cap screws to the
holes next to the rubber foot pad.
Mounting the Leg Bracket
Attached the leg bracket on the left side
of the base by aligning the holes in the
leg bracket with the threaded holes in
the rails located on the underside of the
machine base as shown. Tighten the hex
head bolts.
NOTE: If desirted, the Leg Bracket may
also be installed on the right side of
the base. If this position is desireable,
the Tool Tray must be installed prior
to installing the Leg Bracket.
4