- ページ 4

アクセサリー Gamma X-Stringer XLTのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma X-Stringer XLT 20 ページ。 Electronic stringing machine

ASSEMBLY INSTRUCTIONS

Leg Bracket with Foot Pads

There are four rubber foot pads supplied

with the machine. Two have exposed

threads and two have a spacer sleeve

over the threads. Install the two rubber

foot pads with the exposed threads into

the outer holes on both ends of the leg

bracket.

Mounting the Leg Bracket

Insert two hex head cap screws to the

holes next to the rubber foot pad.

Mounting the Leg Bracket

Attached the leg bracket on the left side

of the base by aligning the holes in the

leg bracket with the threaded holes in

the rails located on the underside of the

machine base as shown. Tighten the hex

head bolts.

NOTE: If desirted, the Leg Bracket may

also be installed on the right side of

the base. If this position is desireable,

the Tool Tray must be installed prior

to installing the Leg Bracket.