Centurion SDO-10 Instrucciones de instalación y manual de usuario - Página 4
Navegue en línea o descargue pdf Instrucciones de instalación y manual de usuario para Abrepuertas de garaje Centurion SDO-10. Centurion SDO-10 19 páginas. Sectional and tilting door opener
Imprimir página
IMPORTANT SAFETY RECOMMENDATIONS
FAILURE TO COMPLY WITH THE FOLLOWING SAFETY RECOMMENDATIONS
MAY RESULT IN SERIOUS PERSONAL INJURY, DEATH AND / OR PROPERTY
DAMAGE.
1. PLEASE READ CAREFULLY AND ADHERE TO ALL SAFETY AND INSTALLATION
RECOMMENDATIONS
2. The installation of your new Automatic Garage Door Opener (herein after referred to as "AGDO")
must be carried out by a technically qualified or licensed person. Attempting to install or repair the
AGDO without suitable technical qualification may result in severe personal injury, death and / or
property damage.
3. The AGDO must only be installed on a properly balanced well functioning garage door. An improperly
balanced or malfunctioning garage door could cause serious personal injury, death and / or property and / or
the AGDO damage. Have a qualified person check and if required, make repairs to your garage door before
installing the AGDO. A manually operated garage door is deemed to be well balanced and aligned if it;
i. requires an equivalent amount of applied force to either manually open or close, and
ii. requires no more than 150N (15kg) of applied force to either manually open or close, and
iii. does not rise or fall more than 100mm when released at any point between fully open or fully
closed positions, and
iv. does not rub on or incorrectly make contact with any supporting or surrounding structures.
4. Repairs to the garage door must be carried out by a technically qualified person. Attempting to repair the
garage door without suitable technical qualification may result in severe personal injury, death and / or
property and / or AGDO damage.
5. Remove or render inoperative all existing locks and ropes prior to installation of the AGDO.
6. The counter balance springs on sectional type garage doors must be lubricated annually between each of the
coils with heavy automotive bearing grease. Failure to adequately lubricate the springs may result in one or
more of the following symptoms:
a. Counter balance springs may become rusty over time resulting in additional operating friction
between the coils which may cause the AGDO to malfunction.
b. Seasonal temperature changes may cause the garage door springs to expand and / or contract. The
resultant increase and / or decrease in operating friction may cause the AGDO to malfunction.
Properly lubricating the springs will help to minimize changes in operating friction due to the
effects of seasonal temperature change.
7. Where possible, install the AGDO at least 2 meters or more above the ground. Adjust the Engage / Disengage
Cord so that it hangs approximately 1.8 meters from the ground.
8. The Engage / Disengage Instruction Tag must remain attached to the Engage / Disengage Cord.
9. Locate the Wall Switch;
i. within site of the garage door, and
ii. at a minimum height of 1.5 meters above the ground so that it remains out of the reach of small
children, and
iii. away from all moving parts of the garage door.
10. The Entrapment Warning Label must be secured in a prominent position adjacent to the Wall Switch.
11. The AGDO must be connected to a properly earthed general purpose 230 ~ 240VAC power outlet which has
been installed by a qualified electrical contractor.
12. Do not connect the AGDO to the power outlet until this manual instructs you to do so.
13. Subsequent to installing and adjusting the AGDO the garage door must stop and reverse direction when it
comes into contact with a 35mm high solid object placed on the floor under the garage door.
14. The correct function of the Safety Obstruction Force System should be checked on a monthly basis.
- 4 -
SDOPD