IKEA DAGLIG Manual - Página 15

Navegue en línea o descargue pdf Manual para Placa IKEA DAGLIG. IKEA DAGLIG 40 páginas. Refrigerator
También para IKEA DAGLIG: Manual del usuario (16 páginas)

Imprimir página

ENGLISH

• If there is no oven beneath the hob insert

a dividing panel at a minimum distance

of 20 mm from the bottom of the hob.

• Do not use silicon sealant between the

appliance and the worktop. Avoid

installing the appliance next to doors

and under windows as hot cookware

may be knocked off the rings when doors

and windows are opened.

• Only an authorized service engineer can

install, connect or repair this appliance.

Use only original spare parts.

Electrical connection

• Before connecting, check that the

nominal voltage of the appliance stated

on the rating plate, corresponds to the

available supply voltage. Also, check the

power rating of the appliance and

ensure that the wire is suitably sized to

suit the appliance power rating (refer to

the "Technical information" chapter). The

rating plate is located on the lower

casing of the hob.

• The appliance is not provided with a

mains cable. Buy the right one from

specialized dealer. Single phase or two-

phase connection requires a mains cable

of minimum 70°C temperature stability.

Cable has been provided with end

sleeves. According to IEC regulations use

for one-phase connection: mains cable 3

x 4mm² and for two-phase connection:

Technical data

Rating Plate

Made in Germany

702.228.18

IKEA of Sweden AB

21552

SE - 343 81 Älmhult

mains cable 4 x 2.5mm². Please respect

in first priority specific national

regulations.

• The appliance works perfectly on AC

230 V, AC 220 V~ or AC 240 V~ 50 Hz

electrical network.

• You must have the means for

disconnection incorporated in the fixed

wiring. Have the appliance connected to

the mains using a device that allows the

appliance to be disconnected from the

mains at all poles with a contact opening

width of at least 3 mm, eg. automatic line

protecting cut-out, earth leakage trips or

fuse.

• You must have the connection and the

connecting links carried out as shown in

the connection diagram (it is located on

the underneath surface of the casing of

the hob). The earth lead is connected to

terminal marked with the symbol and

must be longer than leads carrying

electric current. Tighten the terminal

screws securely! Finally, secure the

connecting cable with the mains cable

cleat and the covering closed by

pressing firmly (lock into place).

Warning! Once connected to the

mains supply check that all

cooking zones are ready for use

by briefly setting each to

maximum power.

Model DAGLIG Typ 60 HAD 56 AO 7,1kW

PNC 949 594 312 04 S NO ............... 220-240V AC 50-60 Hz

230 V

DGT