IKEA Lagan HGA4K Manual de instrucciones - Página 16
Navegue en línea o descargue pdf Manual de instrucciones para Placa IKEA Lagan HGA4K. IKEA Lagan HGA4K 24 páginas. Ikea hobs instruction manual
También para IKEA Lagan HGA4K: Manual del usuario (16 páginas), Manual del usuario (28 páginas), Manual de instrucciones (20 páginas), Manual de instrucciones (24 páginas), Manual de instrucciones (16 páginas)
Imprimir página
ENGLISH
In this case, only cable type H05V2V2-F
T90 must be used. The cable section must
be suitable to the voltage and the working
temperature. The yellow/green earth wire
2
must be approximately 2 cm longer than
the brown (or black) phase wire
(previous figure).
Gas setting conversion
This model is designed for use
with natural gas but can be
converted for use with butane or
propane gas providing the
correct injectors. The injectors not
supplied with the appliance have
to be ordered from After Sales
Service (refer to the Service
chapter).
For data concerning injector replacement,
refer to the chapter Technical information
Warning! Conversion or
replacement can only be
performed by a registered
installer.
To replace injectors:
1. Remove pan support.
2. Remove burner cap and crown.
3. With a socket spanner 7 unscrew and
remove the injectors, replace them with
the ones required for the type of gas in
use.
4. Reassemble the parts, following the
same procedure backwards.
1
2
1
The rating plate is located on the lower
casing of the hob.
Conversion to G2.350 gas
• Auxiliary and semi-rapid burner: after
you assembly the injectors (
following figure), screw their cages
Replace the rating label (placed
near gas supply pipe) with
relevant one for the new type of
gas supply before sealing the
appliance. If the appliance is
already sealed please stick it
directly on the user manual
booklet after Technical
information chapter close to the
rating plate drawing.
You can find this label in
package supplied with
appliance.
If the feeding gas pressure will
be different or variable,
comparing with the required, you
must install an appropriate
pressure adjuster, which is not
supplied with the product and if
needed must be ordered
separately from the local After
Sales Service (refer to the Service
chapter). The pressure adjuster
must be fitted on gas supply
pipe, in compliance with the rules
of the force.
16
in
3