IKEA MATMASSIG Manual - Página 16

Navegue en línea o descargue pdf Manual para Placa IKEA MATMASSIG. IKEA MATMASSIG 28 páginas.
También para IKEA MATMASSIG: Manual (24 páginas), Manual (44 páginas), Manual (44 páginas), Manual (28 páginas), Manual (48 páginas), Manual (36 páginas), Manual (28 páginas), Manual (44 páginas), Manual (29 páginas), Manual (12 páginas), Manual (48 páginas)

Imprimir página
IKEA MATMASSIG Manual
ENGLISH
appliance and the worktop. Do not install
the appliance next to the doors and under
windows. Otherwise, the hot cookware may
fall off the pan supports.
Clearances to combustible surfaces
1 10 mm
130 mm
Adjacent walls, cupboards and protection
for combustible materials: Ensure that the

Electrical connection

Warning! Refer to Safety
chapters.
Connection cable
Caution! Information for
authorised installer only.
Warning!
The appliance must be earthed.
Warning!
Risk of injury from electrical
current.
• The electrical mains terminal is under
voltage.
• Make sure that the electrical mains
terminal is free of voltage.
appliance is installed in accordance with
clauses 6.2.5 and 6.10.1.1 of AS/NZS
5601.1, or clauses 6.9.1 and 6.9.5 of
AS/NZS 5601.2 with regard to clearances
to combustible surfaces and materials, and
clearances to rangehoods and exhaust
fans. To ensure clearances of 200mm from
burners to vertical combustible surfaces
observe the minimum distance requirements
shown in Figure. Clearances to combustible
surfaces wmay be reduced if combustible
surfaces are protected in accordance with
clause 6.10.1.2 of AS/NZS 5601.1, or
clause 6.9.2 of AS/NZS 5601.2
100 mm
• Loose and inappropriate plug and
socket connections. May overheat the
terminal.
• Make sure that the clamping connections
are installed correctly.
• Secure the cable with the strain relief
clamp.
Before connecting, check that the nominal
voltage of the appliance stated on the
rating plate, corresponds to the available
supply voltage. Also, check the power
rating of the appliance and make sure that
the wire is suitably sized to suit the
appliance power rating. Refer to the
Technical data chapter.
For installation into a standard
600mm width benchtop the
clearance specified can not be
achieved and combustible
surfaces must be protected in
accordance with the above
clauses.
16