IKEA IHI75UC6FS0 Instrucciones de instalación y manual de uso y mantenimiento - Página 9
Navegue en línea o descargue pdf Instrucciones de instalación y manual de uso y mantenimiento para Campana de ventilación IKEA IHI75UC6FS0. IKEA IHI75UC6FS0 19 páginas. 36" 91.4 cm island-mount canopy range hood
Imprimir página
Assemble Range Hood
1. Install transition on top of hood (if removed for shipping)
with 2 - 3.5 x 9.5 mm Phillips drive sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
2. Position the 4 vertical supports (A) with the notches
at the bottom and attach to the range hood using
16 - 4.2 x 8 mm T20
screws. Use a T20
®
(or T20
adapter provided) to tighten all assembly screws.
®
A
C
A. Vertical supports
B. Horizontal support
C. Notched end
3. Position the lower horizontal support (B) as shown (flanges
pointed down). Attach to the lower vertical supports using
8 - 4.2 x 8 mm T20
screws. The lower horizontal support
®
can be positioned at any of the three mounting hole
locations in the lower vertical supports.
C
C
A. Vertical supports (4)
B. Horizontal support
C. Screws 4.2 x 8 mm T20
D. Mounting hole locations for horizontal support
Torx
drive
®
®
B
A
C
A B
C
C
D
(8)
®
4. Attach a second set of vertical supports (A) and set
the vertical height (B). See "Installation Dimensions"
in the "Location Requirements" section to help
determine the desired dimension for vertical height "B."
Secure with 16 - 4.2 x 8 mm T20
A
A. Vertical supports
B. Vertical height
Install Range Hood
Non-Vented (recirculating) Installation
1. Attach the air deflector to the upper horizontal support
using 2 - 4.2 x 8 mm T20
B
A
A. Deflector
B. 2 - 4.2 x 8 mm T20
2. Measure the length of 6" (15.2 cm) duct needed
to connect the transition to the deflector.
NOTE: Vent should fit up inside the deflector
1" (2.5 cm) minimum.
3. Install vent between the transition and the deflector.
NOTE: To make vent installation easier, temporarily remove
the deflector from the chimney support bracket and replace
after vent section is in place.
4. Seal all connections with vent clamps. Continue
with "Range Hood Installation" in this section.
Range Hood Installation
1. Using 2 or more people, lift the range hood assembly
and attach it by snapping the vertical supports to the
spring clips in the upper horizontal support bracket
that is mounted to the ceiling.
NOTE: The range hood assembly must be held in place
while you are installing the screws in the next step.
2. Install 16 - 4.2 x 8 mm T20
A
A. Mounting screws
screws.
®
A
B
mounting screws.
®
B
mounting screws
®
screws and tighten to secure.
®
9