- ページ 9

換気フード IKEA IHI75UC6FS0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA IHI75UC6FS0 19 ページ。 36" 91.4 cm island-mount canopy range hood

ページを印刷する

Assemble Range Hood

1. Install transition on top of hood (if removed for shipping)

with 2 - 3.5 x 9.5 mm Phillips drive sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

2. Position the 4 vertical supports (A) with the notches

at the bottom and attach to the range hood using

16 - 4.2 x 8 mm T20

screws. Use a T20

(or T20

adapter provided) to tighten all assembly screws.

A. Vertical supports

B. Horizontal support

C. Notched end

3. Position the lower horizontal support (B) as shown (flanges

pointed down). Attach to the lower vertical supports using

8 - 4.2 x 8 mm T20

screws. The lower horizontal support

can be positioned at any of the three mounting hole

locations in the lower vertical supports.

A. Vertical supports (4)

B. Horizontal support

C. Screws 4.2 x 8 mm T20

D. Mounting hole locations for horizontal support

Torx

drive

A B

(8)

4. Attach a second set of vertical supports (A) and set

the vertical height (B). See "Installation Dimensions"

in the "Location Requirements" section to help

determine the desired dimension for vertical height "B."

Secure with 16 - 4.2 x 8 mm T20

A. Vertical supports

B. Vertical height

Install Range Hood

Non-Vented (recirculating) Installation

1. Attach the air deflector to the upper horizontal support

using 2 - 4.2 x 8 mm T20

A. Deflector

B. 2 - 4.2 x 8 mm T20

2. Measure the length of 6" (15.2 cm) duct needed

to connect the transition to the deflector.

NOTE: Vent should fit up inside the deflector

1" (2.5 cm) minimum.

3. Install vent between the transition and the deflector.

NOTE: To make vent installation easier, temporarily remove

the deflector from the chimney support bracket and replace

after vent section is in place.

4. Seal all connections with vent clamps. Continue

with "Range Hood Installation" in this section.

Range Hood Installation

1. Using 2 or more people, lift the range hood assembly

and attach it by snapping the vertical supports to the

spring clips in the upper horizontal support bracket

that is mounted to the ceiling.

NOTE: The range hood assembly must be held in place

while you are installing the screws in the next step.

2. Install 16 - 4.2 x 8 mm T20

A. Mounting screws

screws.

mounting screws.

mounting screws

screws and tighten to secure.