HIKVISION DS-2CE56D8T-IT3E Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para DVR HIKVISION DS-2CE56D8T-IT3E. HIKVISION DS-2CE56D8T-IT3E 17 páginas. Bullet & turret camera
También para HIKVISION DS-2CE56D8T-IT3E: Manual del usuario (15 páginas), Manual de inicio rápido (17 páginas)
Imprimir página
3. Route the cables through the cable hole, or the side
opening.
4. Install the camera to the ceiling with supplied
screws.
Figure 2-2 Install the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Rotation
Position
[0° to 360°]
1). Loosen the P screw to adjust the pan position [0°
to 360°]. Tighten the screw after completing the
adjustment.
2). Loosen the T screw to adjust the tilt position [0°
to 180°]. Tighten the screw after completing the
adjustment.
3). Loosen the R screw and rotate the camera [0° to
360°]. Tighten the screw after completing the
adjustment.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance. The
installation steps of Type I, Type II, and Type III Camera
are similar and the following takes Type I as an example
to describe the steps.
Steps:
Figure 2-1 The Drill Template
Figure 2-3 3-axis Adjustment
Pan Position
[0°to 360°]
P
Tilt Position [0° to 180° ]
T
R