HIKVISION DS-2CE56D8T-IT3E 사용자 설명서 - 페이지 7

{카테고리_이름} HIKVISION DS-2CE56D8T-IT3E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-2CE56D8T-IT3E 17 페이지. Bullet & turret camera
HIKVISION DS-2CE56D8T-IT3E에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지), 빠른 시작 매뉴얼 (17 페이지)

페이지 인쇄

3. Route the cables through the cable hole, or the side

opening.

4. Install the camera to the ceiling with supplied

screws.

Figure 2-2 Install the Camera to the Ceiling

Note:

The supplied screw package contains self-tapping



screws, and expansion bolts.

For cement wall/ceiling, expansion bolts are



required to fix the camera. For wooden

wall/ceiling, self-tapping screws are required.

5. Connect the corresponding power cord, and video

cable.

6. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, adjust the camera according to the figure below

to get an optimum angle.

Rotation

Position

[0° to 360°]

1). Loosen the P screw to adjust the pan position [0°

to 360°]. Tighten the screw after completing the

adjustment.

2). Loosen the T screw to adjust the tilt position [0°

to 180°]. Tighten the screw after completing the

adjustment.

3). Loosen the R screw and rotate the camera [0° to

360°]. Tighten the screw after completing the

adjustment.

2.1.2 Ceiling/Wall Mounting with Junction Box

Before you start:

You need to purchase a junction box in advance. The

installation steps of Type I, Type II, and Type III Camera

are similar and the following takes Type I as an example

to describe the steps.

Steps:

Figure 2-1 The Drill Template

Figure 2-3 3-axis Adjustment

Pan Position

[0°to 360°]

Tilt Position [0° to 180° ]