CORNING LSE 6710 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Equipos de laboratorio CORNING LSE 6710. CORNING LSE 6710 12 páginas. Digital vortexer
También para CORNING LSE 6710: Manual de instrucciones (9 páginas)

Imprimir página
Power
RPM signal light is on. By rotating the encoder knob right (+) or left (-) the desired RPM can

be selected:
34 = 340 rpm
•
120 = 1,200 rpm
•
Press the Start/Stop button to start operation.

Power
Run and Time signal lights are on. The vortexer runs and counts down the time from the

set value.
NOTE: You cannot modify the set time during vortexing. However, you can stop the unit with
the Start/Stop button and then reset the time.
Power
If you want to change the RPM during vortexing, push the encoder knob to put the vortexer

into RPM set mode (RPM signal light will be on). Rotate the encoder knob right (+) or left
(-) to set the desired value. In the meantime RPM signal light will flash. When you stop
rotating the encoder knob, the signal light for RPM will stop flashing after 2 seconds.
6
CO R N I N G L S E D I G I TA L VO RT E X E R
Run
Time
Speed
Speed(RPMx10) Time (min)
Run
Time
Speed
Speed(RPMx10) Time (min)
Run
Time
Speed
Speed(RPMx10) Time (min)
Start
ENCODER
Stop
PUSH
(Time/Speed)
Start
ENCODER
Stop
PUSH
(Time/Speed)
Start
ENCODER
Stop
PUSH
(Time/Speed)