CORNING LSE 6710 Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лабораторне обладнання CORNING LSE 6710. CORNING LSE 6710 12 сторінок. Digital vortexer
Також для CORNING LSE 6710: Інструкція з експлуатації (9 сторінок)

Друкувати сторінку

Power

RPM signal light is on. By rotating the encoder knob right (+) or left (-) the desired RPM can

be selected:

34 = 340 rpm

•

120 = 1,200 rpm

•

Press the Start/Stop button to start operation.

Power

Run and Time signal lights are on. The vortexer runs and counts down the time from the

set value.

NOTE: You cannot modify the set time during vortexing. However, you can stop the unit with

the Start/Stop button and then reset the time.

Power

If you want to change the RPM during vortexing, push the encoder knob to put the vortexer

into RPM set mode (RPM signal light will be on). Rotate the encoder knob right (+) or left

(-) to set the desired value. In the meantime RPM signal light will flash. When you stop

rotating the encoder knob, the signal light for RPM will stop flashing after 2 seconds.

CO R N I N G L S E D I G I TA L VO RT E X E R

Run

Time

Speed

Speed(RPMx10) Time (min)

Run

Time

Speed

Speed(RPMx10) Time (min)

Run

Time

Speed

Speed(RPMx10) Time (min)

Start

ENCODER

Stop

PUSH

(Time/Speed)

Start

ENCODER

Stop

PUSH

(Time/Speed)

Start

ENCODER

Stop

PUSH

(Time/Speed)