GARAN EWS-102 Configuración del sistema - Página 2

Navegue en línea o descargue pdf Configuración del sistema para Unidad de control GARAN EWS-102. GARAN EWS-102 4 páginas.
También para GARAN EWS-102: Configuración del sistema (4 páginas), Configuración del sistema (4 páginas), Calibración y configuración (8 páginas), Información complementaria (2 páginas)

EWS-102 CONTROL UNIT

To begin the system setup

press the

and

buttons together

Press the

The instrument then counts down from 10 to 1 to allow �me for the operator to ensure that the

Countdown

elevator cabin is empty

The "Zero" point has now been calibrated and stored.

CAL indicates that the calibra�on is now complete (remains for 10 seconds)

Press the

Mul� Analog version only: See note 3 page 1. A�er the EWS 102 calibra�on and setup has been

completed, place the the li� at the lowest floor level and rezero following the process on this page, this

will finalise the Analog output calibra�on.

Firmware 5.5 Rev 2 Booklet subject to alteration

bu�on to enter the zero calibra�on menu

bu�on

bu�on within 10 seconds to proceed to the Load Calibra�on

CALIBRATION ZERO

www.garan.co.uk

Page 2