Avantco Equipment 177MIX8BK Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Mezclador Avantco Equipment 177MIX8BK. Avantco Equipment 177MIX8BK 10 páginas. Commercial countertop mixer with digital controls
Imprimir página
User Manual
Operation
POWER ON AND POWER OFF
After powered on, all of the indicators and the digital display will flash on, and the buzzer will sound for 1
second. If the device was normally shut down before powered off last time, it will enter a standby state after
1 second. The digital displays will all display 0, and the indicator will display speed level 1. If the motor was
running when last powered off, the state before the unit was powered off will be restored after 1 second, but
the motor will change from a running state to a paused state. In case of a shutdown, please stop the motor
first and then unplug the power.
START AND STOP THE MIXER
Before starting the mixer, make sure the bowl is attached and the lift is engaged in the "up" position, then
press the start/stop button to start the motor. Whether the motor is started or not, you can adjust the speed
by pressing the up and down speed button arrows. You can also adjust the timer by pressing the up or down
timer arrows on the display.
If the timer is adjusted after the mixer is started, the adjustment time will not be remembered and will only be
effective for this operation. If the timer is not set to 0, the countdown will start again immediately.
After the mixer is started, press the Start/Pause button in order to temporarily pause the running of the motor.
When the motor is paused, the timer will also stop until the Start button is pressed again, at which time it will
start again.
To return to the standby state, press the Stop button when the mixer is running or suspended.
COUNTDOWN TIMER AND REMINDER
When the countdown is less than 15 seconds, the alarm will sound to notify the user every 2 seconds until the
timer reaches 0 . The motor will stop running automatically and the digital display will flash to show "00" .
Once the timer reaches zero, the alarm will sound once every 10 seconds for 1 minute.
Controls
NOTE: New mixer bowls and agitators (beaters, whip, and dough hook) should be thoroughly washed with
hot water and mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly rinsed
with clean water BEFORE being used. This cleaning procedure should also be followed for bowls and agitators
before whipping egg whites or whole eggs.
ON/OFF: to start or stop operation
SPEED INDICTOR BAR: The speed indicator bar displays which speed (1-5) the mixer is currently set to. If the
mixer senses that there is an uneven load in the mixer bowl, a notification will flash on the display.
TIMER: digital set by 1-30 minutes shows the time in minutes, or in seconds if the timer is less than 1 minute.
If the time is shown in minutes, a dot on the timer display will flash to
signify that it is still counting.
BUTTONS: The buttons on the control panel are as follows:
Start/Pause – Begins or pauses the mixer's motor
Stop – Stops the mixer's motor
Timer Up Arrow – Increases the amount of time on the timer
Timer Down Arrow – Decreases the amount of time on the timer
Speed Up Arrow – Increases the speed of the motor
Speed Down Arrow – Decreases the speed of the motor
5
www.AvantcoEquipment.com