Avantco Equipment 177MIX8BK 사용자 설명서 - 페이지 6

{카테고리_이름} Avantco Equipment 177MIX8BK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco Equipment 177MIX8BK 10 페이지. Commercial countertop mixer with digital controls

페이지 인쇄

User Manual

Operation

POWER ON AND POWER OFF

After powered on, all of the indicators and the digital display will flash on, and the buzzer will sound for 1

second. If the device was normally shut down before powered off last time, it will enter a standby state after

1 second. The digital displays will all display 0, and the indicator will display speed level 1. If the motor was

running when last powered off, the state before the unit was powered off will be restored after 1 second, but

the motor will change from a running state to a paused state. In case of a shutdown, please stop the motor

first and then unplug the power.

START AND STOP THE MIXER

Before starting the mixer, make sure the bowl is attached and the lift is engaged in the "up" position, then

press the start/stop button to start the motor. Whether the motor is started or not, you can adjust the speed

by pressing the up and down speed button arrows. You can also adjust the timer by pressing the up or down

timer arrows on the display.

If the timer is adjusted after the mixer is started, the adjustment time will not be remembered and will only be

effective for this operation. If the timer is not set to 0, the countdown will start again immediately.

After the mixer is started, press the Start/Pause button in order to temporarily pause the running of the motor.

When the motor is paused, the timer will also stop until the Start button is pressed again, at which time it will

start again.

To return to the standby state, press the Stop button when the mixer is running or suspended.

COUNTDOWN TIMER AND REMINDER

When the countdown is less than 15 seconds, the alarm will sound to notify the user every 2 seconds until the

timer reaches 0 . The motor will stop running automatically and the digital display will flash to show "00" .

Once the timer reaches zero, the alarm will sound once every 10 seconds for 1 minute.

Controls

NOTE: New mixer bowls and agitators (beaters, whip, and dough hook) should be thoroughly washed with

hot water and mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly rinsed

with clean water BEFORE being used. This cleaning procedure should also be followed for bowls and agitators

before whipping egg whites or whole eggs.

ON/OFF: to start or stop operation

SPEED INDICTOR BAR: The speed indicator bar displays which speed (1-5) the mixer is currently set to. If the

mixer senses that there is an uneven load in the mixer bowl, a notification will flash on the display.

TIMER: digital set by 1-30 minutes shows the time in minutes, or in seconds if the timer is less than 1 minute.

If the time is shown in minutes, a dot on the timer display will flash to

signify that it is still counting.

BUTTONS: The buttons on the control panel are as follows:

Start/Pause – Begins or pauses the mixer's motor

Stop – Stops the mixer's motor

Timer Up Arrow – Increases the amount of time on the timer

Timer Down Arrow – Decreases the amount of time on the timer

Speed Up Arrow – Increases the speed of the motor

Speed Down Arrow – Decreases the speed of the motor