CORNING ONE HEU Hoja de instalación rápida

Navegue en línea o descargue pdf Hoja de instalación rápida para Instrumentos de medida CORNING ONE HEU. CORNING ONE HEU 12 páginas. Headend unit

This document describes the installation procedure for the Corning® optical network evolution (ONE™) headend unit (HEU)

and relevant modules.

REQUIRED KITS

The following items are required for installing the ONE™ HEU. If any of the listed items are missing, contact your

Corning representative.

HEU Kit

Headend Unit Chassis (with blank panels on RIM and

one PSM slots) – includes factory-installed FAM in chassis

rear

FAM – single unit hosting four fans

(factory installed in chassis rear)

RJ45/RJ45 Communication Cable L = 2 m-2.15 m

(P/N 705900003) – HCM management cable

RIMe Kit (1-12 according to order)

Extended Radio Interface Module (service specific)

Table 1. Kits Required for HEU Installation

Corning Optical Communications

Headend Unit (HEU)

Quick Installation Sheet

CMA-267-AEN

GENERAL INFORMATION

1. The HEU chassis is supplied empty and only includes the factory-

assembled fan module (FAM). All other modules are ordered separately

and must be installed.

2. Each HEU includes 14 slots — two for RF expander modules (RIXs) and

12 for extended radio interface modules (RIMes).

Qty

Item

Quick Installation Sheet | CMA-267-AEN | Page 1