CORNING EDC-02P-NH Manual - Página 4

Navegue en línea o descargue pdf Manual para Recinto CORNING EDC-02P-NH. CORNING EDC-02P-NH 7 páginas. Environmental distribution center
También para CORNING EDC-02P-NH: Manual (12 páginas)

Imprimir página

Step 2:

remove the top nut and the two washers from the bracket.

Step 3:

Loosen the remaining nut.

Step 4:

Insert central member of the cable between the U-shaped washer and bracket.

•

Arrange the buffer tubes to ensure clearance around the central member clamp assembly.

Step 5:

Retighten the nut and reinstall the two flat washers.

Step 6:

Loosely install the other hex nut.

Step 7:

Wrap the yarn around the bolt in a clockwise direction between the flat washers.

Step 8:

tighten the second hex nut.

Step 9:

trim off the excess yarn.

COMPLETE GROUNDING

(WITH HDWR-GRND-KIT)

mount grounding bus to the back plate with the

provided screws and connect grounding wires

as shown.

CABLE ROUTING

CAUTION: Fiber optic cable is sensitive to excessive pulling, bending, and crushing forces. Consult

the cable specification sheet for the cable you are installing. Do not bend the cable more sharply than

the minimum recommended bend radius. Do not apply more pulling force to the cable than specified.

Do not crush the cable or allow it to kink. Doing so may cause damage that can alter the transmission

characteristics of the cable; the cable may have to be replaced.

9.1. For Splicing to Pigtailed Panels or Modules

Step 1:

Install pigtailed panel or module into connector panel bracket.

Step 2:

route buffer tube(s) and pigtail(s) in a counterclockwise direction around the radius guides

with one loop per section, starting with the back section.

•

tWO complete loops for eDC-02p-NH

•

tHree complete loops for eDC-06/12p-NH

STANDARD RECOMMENDED PROCEDURE 003-304 | ISSUE 10 | September 2010 | PAGE 4 OF 7

Buffer Tubes

Central Member

U-shaped Washer

Yarn

Central Member

Bracket

TPA-2919

Yarn

TPA-2917

Buffer Tubes

TPA-2918