Makita 5143R Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita 5143R. Makita 5143R 13 páginas. Circular saw
También para Makita 5143R: Manual de instrucciones (13 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (12 páginas), Manual de instrucciones (16 páginas)

Imprimir página

CAUTION:

•

Do not use saw blades which do not comply

with the characteristics specified in these

instructions.

•

Do not use saw blades the disc of which is

thicker or the set of which is smaller than the

thickness of the riving knife.

► 1 . Hex wrench 2. Shaft lock

CAUTION:

•

Be sure the blade is installed with teeth pointing

up at the front of the tool.

•

Use only the Makita wrench to install or remove

the blade.

•

Never depress the shaft lock while the saw is

running.

To remove the blade, press the shaft lock fully so that

the blade cannot revolve and use the hex wrench to

loosen the hex bolt counterclockwise. Then remove the

hex bolt, outer flange and blade.

To install the blade, follow the removal procedure in

reverse. BE SURE TO TIGHTEN THE HEX BOLT

CLOCKWISE SECURELY.

► 1 . Hex socket head bolt 2. Outer flange 3. Saw

blade 4. Inner flange

When changing blade, make sure to also clean upper

and lower blade guards of accumulated sawdust. Such

efforts do not, however, replace the need to check lower

guard operation before each use.

9 ENGLISH

Connecting a vacuum cleaner

► 1 . Vacuum cleaner

When you wish to perform clean cutting operation, con-

nect a Makita vacuum cleaner to your tool. Install the

joint on the tool using the screws. Then connect a hose

of the vacuum cleaner to the joint as shown in the figure.

OPERATION

CAUTION:

•

Be sure to move the tool forward in a straight

line gently. Forcing or twisting the tool will result

in overheating the motor and dangerous kick-

back, possibly causing severe injury.

Hold the tool firmly. The tool is provided with both a front

grip and rear handle. Use both to best grasp the tool. If

both hands are holding saw, they cannot be cut by the

blade. Set the base on the workpiece to be cut without

the blade making any contact. Then turn the tool on and

wait until the blade attains full speed. Now simply move

the tool forward over the workpiece surface, keeping it flat

and advancing smoothly until the sawing is completed.

To get clean cuts, keep your sawing line straight and your

speed of advance uniform. If the cut fails to properly follow

your intended cut line, do not attempt to turn or force the tool

back to the cut line. Doing so may bind the blade and lead

to dangerous kickback and possible serious injury. Release

switch, wait for blade to stop and then withdraw tool. Realign

tool on new cut line, and start cut again. Attempt to avoid posi-

tioning which exposes operator to chips and wood dust being

ejected from saw. Use eye protection to help avoid injury.