Makita AN621 Manual de instrucciones - Página 14

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita AN621. Makita AN621 19 páginas. Makita an621 coil nailer: specifications
También para Makita AN621: Desglose de piezas (3 páginas)

Imprimir página

Continuous nailing and trigger locking method

For continuous nailing, set the change lever to the

"Continuous Nailing" position. For locking the trig-

ger, set the change lever to the "Lock" position.

Always make sure that the change lever is properly

set to the position.

CAUTION:

Operating the tool without nails shortens the life of the tool and should be avoided.

Air exhaust

Air exhaust direction can be changed easily by rotat-

ing the exhaust cover. Change it when necessary.

. .

Jammed nailer

CAUTION:

Always lock the trigger, disconnect the hose and remove the nails from the magazine before cleaning

a jam.

When the nailer becomes jammed, proceed as fol-

lows:

Open the door and magazine cap and remove the nail

coil. Insert a small rod or the like into the ejection port

and tap it with a hammer to drive out the nail jam-

ming the ejection port. Reset the nail coil and close

the magazine cap and door.

Small rod

Hook

The hook is convenient for hanging the tool tempo-

rarily. This hook can be installed on either

side of the

tool.

CAUTION:

=Always lock the trigger and disconnect the hose when hanging the tool using the hook.

=Always tighten the hook securing bolt firmly. Loose bolt may cause air leakage from the tool.