Makita AN621 Руководство по эксплуатации - Страница 14
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Makita AN621. Makita AN621 19 страниц. Makita an621 coil nailer: specifications
Также для Makita AN621: Разбивка на части (3 страниц)
Печатать страницу
Continuous nailing and trigger locking method
For continuous nailing, set the change lever to the
"Continuous Nailing" position. For locking the trig-
ger, set the change lever to the "Lock" position.
Always make sure that the change lever is properly
set to the position.
CAUTION:
I
Operating the tool without nails shortens the life of the tool and should be avoided.
Air exhaust
Air exhaust direction can be changed easily by rotat-
ing the exhaust cover. Change it when necessary.
. .
.
.
.
I
Jammed nailer
CAUTION:
Always lock the trigger, disconnect the hose and remove the nails from the magazine before cleaning
a jam.
When the nailer becomes jammed, proceed as fol-
lows:
Open the door and magazine cap and remove the nail
coil. Insert a small rod or the like into the ejection port
and tap it with a hammer to drive out the nail jam-
ming the ejection port. Reset the nail coil and close
the magazine cap and door.
mr
Small rod
Hook
The hook is convenient for hanging the tool tempo-
rarily. This hook can be installed on either
side of the
tool.
CAUTION:
=Always lock the trigger and disconnect the hose when hanging the tool using the hook.
=Always tighten the hook securing bolt firmly. Loose bolt may cause air leakage from the tool.
14