KitchenAid 30" Slide-in Range Manual de instrucciones de instalación - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Gamas KitchenAid 30" Slide-in Range. KitchenAid 30" Slide-in Range 13 páginas. 30" (76.2 cm) sealed burner gas range with self-cleaning thermal/convection oven

Imprimir página

Cabinet dimensions/requirements

Cabinet opening dimensions shown are for:

25" (63.5 cm) countertop depth, 24" (61 cm) base

cabinet depth, 36" (91.4 cm) countertop height

Freestanding or Slide-in Range

4" (10.2 cm) min. clearance from

both sides of range to side wall

or other combustible material.

Gas line opening

should be located

within this shaded area

Floor gas line

opening if directly

below regulator

IMPORTANT: Some cabinet and building

materials are not designed to withstand

the heat produced by the oven for baking

and self-cleaning. Check with your builder

or cabinet supplier to make sure that the

materials used will not discolor,

delaminate or sustain other damage.

• Do not pinch the power supply cord

between the range and the wall.

• Do not seal the range to the side cabinets.

• Contact a qualified floor covering installer to

check that the floor covering can withstand

at least 200°F (93°C).

• Use an insulated pad or 1/4" (6 mm)

plywood under range if installing range over

carpeting.

IMPORTANT: Rear vent must not be

obstructed for proper ventilation on all

slide-in models. See step 6, page 7.

9" (22.9 cm)

3" (7.6 cm)

2-1/2" (6.4 cm)

2" (5.1 cm)

Anti-tip bracket

The floor-mounted anti-tip bracket

must be installed. To install the

anti-tip bracket supplied, see page 3

and the anti-tip bracket template/

instruction sheet.

13" (33 cm) max.

upper cabinet depth

30" (76.2 cm) cabinet

opening width

30" (76.2 cm)

opening width

18"

(45.7 cm)

2-1/2"

(6.4 cm)

10" (25.4 cm)

24" (61 cm)

7/8" (2.2 cm) min.

required between

cabinet opening and

door or hinge opening

* NOTE: 24" (61 cm) min. when bottom of wood or

metal cabinet is protected by not less than

1/4" (6.4 mm) flame retardant millboard covered

with not less than No. 28 MSG sheet steel, 0.015"

(0.4 mm) stainless steel, 0.024" (0.6 mm)

aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) min. clearance between the top of

the cooking platform and the bottom of an

unprotected wood or metal cabinet.

For minimum

18" (45.7 cm)

clearance to

upper side cabinet

cooktop, see

to countertop

NOTE*.

6" (15.2 cm)

Outlet should be

located within the

18" x 10"

(45.7 x 25.4 cm)

shaded area