Makita BJV180 Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita BJV180. Makita BJV180 13 páginas. Cordless jig saw
También para Makita BJV180: Desglose de piezas (3 páginas), Hoja de especificaciones (2 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (13 páginas), Información técnica (13 páginas), Manual de instrucciones (18 páginas)
Imprimir página
Do not touch the blade or the workpiece
•
immediately
after
extremely hot and could burn your skin.
Tighten the saw blade securely. Failure to do so
•
may cause a serious injury.
When you remove the saw blade, be careful not to
•
hurt your fingers with the top of the blade or the tips
of workpiece.
To install the blade, open the tool opener to the position
shown in the figure.
1
001909
Keeping that situation, insert the saw blade into the
blade clamp as far as the two protrusions of the blade
can not be seen.
3
1
2
001910
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the
position shown in the figure. Pull the saw blade out
toward the base.
1
001911
operation;
they
may
1. Tool opener
1. Blade clamp
2. Jig saw blade
3. Protrusions
1. Jig saw blade
NOTE:
be
Occasionally lubricate the roller.
•
Hex wrench storage
1
007486
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Cover plate
007503
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
Anti-splintering device
007504
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
CAUTION:
The anti-splintering device cannot be used when
•
making bevel cuts.
7
1. Base
2. Hex wrench
2
1. Cover plate
1
2. Base
2
1. Base
2. Anti-splintering
device
1
2