Makita BJV180 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita BJV180. Makita BJV180 13 páginas. Cordless jig saw
También para Makita BJV180: Desglose de piezas (3 páginas), Hoja de especificaciones (2 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (13 páginas), Información técnica (13 páginas), Manual de instrucciones (18 páginas)

Imprimir página
Makita BJV180 Manual de instrucciones
Tilt the base until the desired bevel angle is obtained.
The V-notch of the gear housing indicates the bevel
angle by graduations. Then tighten the bolt firmly to
secure the base.
1
3
2
007490
Front flush cuts
2
1
007491
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then tighten
the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole:
007492
For internal cutouts without a lead-in cut from an
•
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start your
cut.
1. Bevel slot
2. Base
6
3. Bolt
5
4. Graduations
5. V-notch
4
6. Gear housing
1. Base
3
2. Bolt
3. Hex wrench
1. Starting hole
1
B) Plunge cutting:
007493
You need not bore a starting hole or make a lead-in
•
cut if you carefully do as follows.
1.
Tilt the tool up on the front edge of the base with
the blade point positioned just above the
workpiece surface.
2.
Apply pressure to the tool so that the front edge of
the base will not move when you switch on the
tool and gently lower the back end of the tool
slowly.
3.
As the blade pierces the workpiece, slowly lower
the base of the tool down onto the workpiece
surface.
4.
Complete the cut in the normal manner.
Finishing edges
007494
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.
Rip fence set (optional accessory)
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing accessories.
9