HIKVISION DS-3WF02C-5N/O Manual de inicio rápido - Página 14

Navegue en línea o descargue pdf Manual de inicio rápido para Hardware de red HIKVISION DS-3WF02C-5N/O. HIKVISION DS-3WF02C-5N/O 16 páginas.

Step 2 Go to the device page and click the "Wizard" bar at the top of the page to enter the

"Network" page to set the IP address of the device. In the address field of the LAN IP, fill in

192.168.1.X, X is any integer from 2 to 253, and the address is not used. The subnet mask can be

used by default. Click "Next" when finished.

Step 3 Go to the "Wireless" page. The device can modify the wireless parameters such as network

name, frequency, and key through this page. The default wireless mode of the device is the WDS

Station. The default network name of the device is Wireless_R. When pairing with the WDS Access

Point device, please note that the key and the SSID on the WDS Station side must be the same as

the WDS Access Point. Other configurations are recommended to keep the default values. Click

"Next".

Step 4 Go to the Setup "Wizard – Finish" page and click "Change" to save the configuration.

DS-3WF02C-5N/O Quick Start Guide

Figure 4-2 Wizard – Network

Figure 4-3 Wizard – Wireless