Lexmark C925 Manual del administrador - Página 11

Navegue en línea o descargue pdf Manual del administrador para Impresora Lexmark C925. Lexmark C925 12 páginas. Setup sheet
También para Lexmark C925: Manual del administrador (20 páginas), Manual del administrador (12 páginas), Manual de conexión (7 páginas), Nota de publicación (4 páginas), Manual del administrador (13 páginas), Manual de mantenimiento (15 páginas), Manual (14 páginas), Referencia rápida (10 páginas), Manual en papel (3 páginas), Mapa del menú (2 páginas), Manual de mudanzas (2 páginas), Manual de suministros (2 páginas), Manual de información (1 páginas), Manual de defectos de impresión (1 páginas), Instalación (2 páginas), Referencia rápida (12 páginas), Formación (18 páginas)

Imprimir página
Lexmark C925 Manual del administrador

Troubleshooting

Showroom troubleshooting

Error reading USB drive
Although most USB flash drives should work with your printer, a few may not be compatible. At a minimum, your USB
drive should:
•
Be USB 2.0-compatible
•
Support the Full Speed standard (low-speed devices will not work)
•
Have a USB type "A" connector
•
Support the FAT file system (NTFS file system not supported)
For a list of tested and approved USB flash drives, visit the Lexmark Web site at www.lexmark.com.
Nothing happens when USB drive is inserted
If nothing happens within a few seconds after you insert your USB drive, then the USB ports may be disabled on the
printer. Contact your system support person for more information.
"There are no images to display" error message appears
For images stored on a USB drive
•
Remove and reinsert the USB drive to make sure it is properly seated in the printer USB port.
•
From the application configuration settings in the Embedded Web Server:
–
Make sure that Enable USB drive is selected.
–
Make sure the directory path to the image files is correct.
–
Make sure that the file size and type are supported. For more information, see the mouse-over help.
–
Click Apply to make sure the configuration has been saved.
For images added through the Embedded Web Server
•
From the application configuration settings in the Embedded Web server:
–
Make sure that is a list of image files under Showroom Slides.
–
Make sure that the file size and type are supported. For more information, see the mouse-over help.
–
Click Apply to make sure the configuration has been saved.
"Image size exceeds limit" error message appears
If the "Image size exceeds limit" appears, verify that each image file stored on the USB drive or in the Embedded Web
Server is no larger than the specified limit.
Troubleshooting
11