Lexmark C925 Manuale dell'amministratore - Pagina 11

Sfoglia online o scarica il pdf Manuale dell'amministratore per Stampante Lexmark C925. Lexmark C925 12. Setup sheet
Anche per Lexmark C925: Manuale dell'amministratore (20 pagine), Manuale dell'amministratore (12 pagine), Manuale di connessione (7 pagine), Nota di rilascio (4 pagine), Manuale dell'amministratore (13 pagine), Manuale di manutenzione (15 pagine), Manuale (14 pagine), Riferimento rapido (10 pagine), Paper Manual (3 pagine), Mappa del menu (2 pagine), Manuale di trasloco (2 pagine), Manuale delle forniture (2 pagine), Manuale informativo (1 pagine), Manuale dei difetti di stampa (1 pagine), Installazione (2 pagine), Riferimento rapido (12 pagine), Servizio di formazione (18 pagine)

Troubleshooting

Error reading USB drive

Although most USB flash drives should work with your printer, a few may not be compatible. At a minimum, your USB

drive should:

•

Be USB 2.0-compatible

•

Support the Full Speed standard (low-speed devices will not work)

•

Have a USB type "A" connector

•

Support the FAT file system (NTFS file system not supported)

For a list of tested and approved USB flash drives, visit the Lexmark Web site at www.lexmark.com.

Nothing happens when USB drive is inserted

If nothing happens within a few seconds after you insert your USB drive, then the USB ports may be disabled on the

printer. Contact your system support person for more information.

"There are no images to display" error message appears

For images stored on a USB drive

•

Remove and reinsert the USB drive to make sure it is properly seated in the printer USB port.

•

From the application configuration settings in the Embedded Web Server:

–

Make sure that Enable USB drive is selected.

–

Make sure the directory path to the image files is correct.

–

Make sure that the file size and type are supported. For more information, see the mouse-over help.

–

Click Apply to make sure the configuration has been saved.

For images added through the Embedded Web Server

•

From the application configuration settings in the Embedded Web server:

–

Make sure that is a list of image files under Showroom Slides.

–

Make sure that the file size and type are supported. For more information, see the mouse-over help.

–

Click Apply to make sure the configuration has been saved.

"Image size exceeds limit" error message appears

If the "Image size exceeds limit" appears, verify that each image file stored on the USB drive or in the Embedded Web

Server is no larger than the specified limit.

Troubleshooting