Gardena 879 Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Pulverizador de pintura Gardena 879. Gardena 879 9 páginas. 3l/5l

Imprimir página

1. Assembly

5. Cleaning

Cleaning the Pressure

Sprayer :

6. Trouble-Shooting

Cleaning the filter :

Problem

Pump does not build up

pressure.

Pressure Sprayer does not

spray although there is

sufficient pressure or only

sprays with a weak spray jet.

It is difficult to open and

close the container.

If you have any other problems with your Pressure Sprayer please contact GARDENA Customer

Service.

Always clean your Pressure Sprayer after spraying.

v Fill the Pressure Sprayer with clean water (the water may

contain some washing-up liquid if necessary) and empty out

the water by spraying it through the spray tube in the same

way as when spraying a product.

This cleans the valves, the spray tube and the nozzles.

We recommend that you have your Pressure Sprayer thoroughly

inspected (preferably at a GARDENA Service Centre) after

using it for 5 years.

If the spray jet from the Pressure Sprayer is very weak you

should clean the filter in the container.

Pressure Sprayer Art. No. 867 / 869

1. Unscrew the container cap.

2. Flip up the filter

3. Close the filter

Pressure Sprayer Art. No. 875 / 879 / 880

Remove the filter

Possible Cause

Container cap is not airtight.

Safety valve is loose.

Hose connection at the container v Tighten the hose connec-

and hand valve is not tight.

Continuous lock enabled on

handle.

Nozzle is blocked.

Filter is blocked.

Container pressure too high.

and rinse under running water.

and screw the container cap back on.

from the spray tube

Remedy

v Fasten the container cap

as tight as it will go

(Art. 867 / 869).

v Tighten the safety valve.

tions at the container and

hand valve.

v Take off the permanent lock

at the hand valve.

v Clean the nozzle.

v Clean the filter in the

container (Art. 867/ 869).

Clean the filter in the spray

tube (Art. 875 / 879 / 880).

v Release the container pres-

sure completely by means

of the safety valve.

Grease the container O-ring

with acid-free grease

(Art. 867/ 869).

and clean it.