Alien Aircraft Corp AK-504 BB Instrucciones de montaje - Página 5
Navegue en línea o descargue pdf Instrucciones de montaje para Juguete Alien Aircraft Corp AK-504 BB. Alien Aircraft Corp AK-504 BB 5 páginas. Internal bombay
Imprimir página9...Cut the 1/32" x 12" music wire in half to make two 6" pieces.
Make a 1/4" long 90 degree bend in one end of each wire. Cut
the two 1/16" aluminum tubes to a length of 3-3/8".
10...Slide the tubes onto the music wire. Position the tube 1/2"
from the 90 degree bend and secure the tube to the wire with
thin C/A glue.
12...With the doors open, feed the bent ends of the wire through
the openings in B-05. Gently spring the ends and insert the
wires into the holes in the arms on the doors.
13...With glue or thin servo tape, mount the servo to the top of
the bombay in the position shown. Install an EZ connector on
the servo arm. Bent the top end of the pushrods as shown and
insert them into the EZ connector.
Adjust the pushrods so that the doors just close when the servo
is in the full up position. Tighten the screw on the EZ connector
to hold the wires in place. Trim the wires off close to the con-
nector and lock them in place with a small drop of thin C/A
glue.
Mount the bombay in the bottom of the fuselage with the
pushrods at the rear. Connect the servo to the receiver.
Page 5